AAH Back Massage Inc.

A Revolutionary Back Massage Solution

To mount the massaging apparatus:

1. Apply one part of VELCRO ™ to the wall or other sturdy surface.

2. Apply the opposing part of the VELCRO ™ to the flat bottom of the massage apparatus. 

3. Repeat step 1  by applying another strip of VELCRO ™ above or below the previous one on the wall.  Multiple VELCRO ™ strips allow you to mount the massage apparatus at several heights to apply massage to different areas of the back muscles.

How to use the massaging apparatus:

 

 

1. Stand with your back towards the massaging apparatus. Start out with your feet placed close to the base of the wall where the massager is mounted.

2. Place the muscle(s) you desire to massage onto a single or both protruding digit(s).

3. Lean into the digit(s) to apply pressure.

4. Adjust a combination of feet placement and contact between back muscle(s) and protruding digits. (the further your feet are from the base of the wall the deeper the muscle massage)

5. To massage a different area of the back muscle(s), adjust the height of the apparatus by removing it from the VELCRO ™ on the wall, and re-attaching to a different height.

 

Notes:

  • To avoid injury:
    • Consult with your physician before use.
    • Avoid making any contact between the massaging apparatus and spinal bones or any other bones in the body.
    • Be sure the opposing VELCRO ™ pieces make full and secure contact when mounting massaging apparatus. If not, the massaging apparatus can fall causing harm to the floor surface or anything underneath.
    • When using the massaging apparatus be aware of body movement. Slow and gentle movement is recommended. Fast and forceful body movement can cause the massaging apparatus to dislodge from the VELCRO ™ and fall to the floor.
  • This massaging apparatus is intended for muscle massage only. The spacing between the two digits is  intended to allow the user to apply pressure to muscles on both sides of the spine at once avoiding the spine itself, or to a single muscle using a single digit.
  • VELCRO ™ applied directly to wall is not removable without damaging the wall's surface. As a suggestion a wooden board (not included) can be used to secure the VELCRO ™ to, and the board secured to the wall using screws or COMMAND STRIPS ™.
  • See FAQ section.